Special Features -

• 3/8" mild steel* capacity
• 1/4" stainless steel** capacity
• 8-7/8" x 8-7/8" 90° notch
• Front to back cutting to hold material against stop
• Milled bed surface for no float or stick operation
• 43" wide by 31" deep table
• Four material hold downs
• Hi-Carbon, Hi-Chrome blades that overlap on the cutting edge to eliminate blade chipping
• Internal stop for shearing
• Three sets of engraved brass scales for accurate and easy setup
• Two heavy duty stops with 19" sliding bars
• Engraved brass scales
• Moveable electric foot pedal
• Adjustable stroke length, 35 per minute
• Solid state circuitry
• Jog, single or continuous mode
• 6.5 horsepower drive motor
• Scrap bucket
• One scale and two T-slots parallel to the blades
• Scale on left and right side of table top
• Scale and T-slot left to right at front of table

* mild steel designated as 50,000 psi
** Stainless designated as 75,000 psi

BOSCHERT Patented Quality -

The patented Boschert TRI-GIDE™ system gives all Boschert notching machines the greatest accuracy and durability of any notcher made today.

TRI is for the three large guiding cylinders. Two cylinders are in the top of the machine, close to the blades, the third is in the base and fully integrated with the hydraulic piston.

GIDE is for the precise vertical travel of the ram. Torque from cutting heavy material is distributed evenly to all three cylinders.

TRI-GIDE™ Eliminates -

• Blade clearance adjustment for different material thicknesses
• Frequent blade sharpening due to sloppy guiding
• Uneven wear, and replacement problems with traditional guiding systems

Exclusive TRI-GIDE™ Benefits -

• Long blade life due to precise, rigid ram guiding
• Burr-free cuts on all gauges (within capacity)
• Off-center loading – 1" x 6" notch is no problem

TRI-GIDE™ is just part of the overall quality and ingenuity that goes into every Boschert Notcher. Other features include:

• Front-to-Back cutting - holds material against stops
• Milled table surface – keeps material from sticking
• Hi-Carbon Hi-chrome Blades – overlap on the cutting tip to eliminate blade chipping
• Thousands of machines installed in North America
• Parts for all machines ever built are available

Close-up of material stop bars with 19" sliding bars on Golden Eagle

(Picture shows plexiguard and holddowns removed for better detail)