Special Features -

• 5/32" mild steel* capacity
• 11 ga. stainless steel** capacity
• 5.9" x 5.9" notch
• All Angles from 30° to 120° without blade or clearance changes
• Front to back cutting to hold material against stop
• Milled bed surface for no float or stick operation
• 39.4" wide by 25.6" deep table
• Two 30° upper blades working directly with two
  correpondending lower blades
• Blades are automatically shifted by pneumatic power
• Hi-Carbon, Hi-Chrome blades that overlap on the
  cutting edge to eliminate blade chipping
• T-slots and engraved brass scales on the table
• Two heavy duty adjustable stops with 12" sliding bars
• Engraved brass scales
• Solid-state circuitry with moveable electric foot pedal
• Jog, single or continuous mode
• Ability to notch into the bend of a 90° angle
• Clear view of the blades tips
• 6.5 horsepower drive motor
• Scrap bucket

* mild steel designated as 50,000 psi
** Stainless designated as 75,000 psi

BOSCHERT Patented Quality -

The patented Boschert TRI-GIDE™ system gives all Boschert notching machines the greatest accuracy and durability of any notcher made today.

TRI is for the three large guiding cylinders. Two cylinders are in the top of the machine, close to the blades, the third is in the base and fully integrated with the hydraulic piston.

GIDE is for the precise vertical travel of the ram. Torque from cutting heavy material is distributed evenly to all three cylinders.

TRI-GIDE™ Eliminates -

• Blade clearance adjustment for different material thicknesses
• Frequent blade sharpening due to sloppy guiding
• Uneven wear, and replacement problems with
  traditional guiding systems

Exclusive TRI-GIDE™ Benefits -

• Long blade life due to precise, rigid ram guiding
• Burr-free cuts on all gauges (within capacity)
• Off-center loading – 1" x 6" notch is no problem

TRI-GIDE™ is just part of the overall quality and ingenuity that goes into every Boschert Notcher. Other features include:

• Front-to-Back cutting - holds material against stops
• Milled table surface – keeps material from sticking
• Hi-Carbon Hi-chrome Blades – overlap on the cutting tip to eliminate blade chipping
• Thousands of machines installed in North America
• Parts for all machines ever built are available

How the BOSCHERT SYSTEM Works -

A 30° upper blade is directly connected to two corresponding lower blades. All notches of more than 30° are accomplished automatically with a right and left notch. Pneumatic power rotates the blades after each stroke.

Also available with punching or coping station

Close-up of material stop bars with 19" sliding bars on the

K 30-120